Saturday, April 16, 2022

Motor mods.

Motors are hold backto back by 4 m4 screws on the inside of the housing but the magnets needs to be aligned to each other to work as a single motor, i´ve do that by using a scrap magnet to identifie the corret position on each motor than made a mark on each motor and joined the two into one by the 4mm screws.again take your time on this step as the 2 motors needs to work in sinc to each other.
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

The code

// this code was adapted from Drew Dibble original code to run on arduino due //you´ll need a library called "soft_uart.h" ,elap...

  • Gear transmission
    this is how i´ve made the bikes main gear transmission, it´s a 3 sprocket standard main gear had to buy 2 sets i´had to drill out the rivet...
  • Motor mods.
    Motors are hold backto back by 4 m4 screws on the inside of the housing but the magnets needs to be aligned to each other to work as a sin...