Saturday, April 16, 2022

What is needed

Here is what you need: CAUTION!!! do not attempt to load arduino code with the hoverboard board turned on or it might damage your pc! guess how i found that out. a working hoverboard a old MTB bike. a throtlle controller 0- to 3.3v a arduino due or other arduino that works with 3.3v. tools and a welder, and a 3d printer if you want to print bat holder.
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

The code

// this code was adapted from Drew Dibble original code to run on arduino due //you´ll need a library called "soft_uart.h" ,elap...

  • Gear transmission
    this is how i´ve made the bikes main gear transmission, it´s a 3 sprocket standard main gear had to buy 2 sets i´had to drill out the rivet...
  • Motor mods.
    Motors are hold backto back by 4 m4 screws on the inside of the housing but the magnets needs to be aligned to each other to work as a sin...